For pedestrian crossing, center line, slip road and other heavy traffic use,
Only 6.5 mm above the road surface,
40 tons compression resistance,
500 m visible,Spot lighting:
flexible solar panel,
Aluminum alloy shell+Polycarbonate+Epoxy Salt-water resistant aluminum
φ5mm, one-way 3pcs, two-way 6pcs
flash (1HZ or customized)
white, yellow, red, blue, green
Flexible solar panel 2v120ma
LiFePO4 3.2v 1500mah
|Battery Life span||
More than 3Years
|Full charge time||
3 hours @100 klux(sunny day)
72 hours after full charge
G# satellite's signal calibration
over 40 tons
|Water ingress rating||
RSAS RS Road Stud A aluminum S Solar
1 One Side 2 Two Side
1.Preparation. Wear correct personal protection equipment and lay the work zone safety equipment properly.
2. Confirm the installation position. Make sure the road surface is flat.
4.Drill a hole with a diameter127mm depth60mm with the core drill.
5.Use air pick to remove the bitumen inside the hole. Remove all debris in the hole and make sure the bottom is flat.
6.Wait till the hole is dry.Spread some epoxy glue all over the hole and insert the road stud.
7.Make sure the LEDs face the direction of traffic.
8.Press the road stud to make it firmly installed, leaving the four wings mounted on the road surface.
9.Remove the spilt glue.
10.Two hours after the installation, go and check all solar road studs to make sure they are installed in right direction and horizontal to the road surface.
11.Take away the work zone safety equipment after two hours.
• Pedestrian crossing, road delineation
• Accident black-spots / cluster sites
• Hazardous road layouts
• Areas adversely affected by poor visibility
• Cycle path
• Car parks
• Before speed hump